Storage and installation instructions for Forrer filter nozzles

  1. The filter nozzles have to be treated carefully at unpacking – not pouring out.
  2. The storage of the filter nozzles should comply with lightproofing and normal temperature specifications.
  3. Before the installation, the surfaces of the holders have to be cleaned and there shall be no impurities in the thread.
  4. The filter nozzles have to be screwed in manually and tighten with a torque wrench. The torque should be in the range of 6.0 – 8.0 Nm.
  5. The particle size diameter of the used filter material should not be smaller then 0.5 mm.
  6. For the cleaning of the filter nozzles no organic solvents are allowed to be used.
  7. The holders have to be clamped in the Installation device such that no cracks arise.
  8. The 'stepping' on the screwed in filter should be avoided.
Storage and installation instructions for Forrer filter nozzles

Unsere neuen Produkte

featured products

forrer QuickScan

Aktuelle Produkte anzeigen